NightDriverStrip Setup

Project Type

Pick The Thing You Built

Choose the starter image closest to your hardware. Specific legacy builds remain available under Advanced Installer.

Runtime Configuration

Set The LED Output

LED Count Data GPIO Color Order Brightness Power Limit mW Effect Rotation sec

Settings Payload

Flash

Connect And Install

Connect the ESP32 over USB, then use the installer dialog to flash the selected image. When prompted, enter WiFi credentials so the device can join your network.

Selected firmware

No project selected.

Advanced Flash Settings

Flash Baud Rate The ROM and WiFi provisioning handshake starts at 115200; firmware writing uses this selected rate after the stub is running.

Use Chrome, Edge, or another browser with Web Serial support. Open this installer over HTTPS or localhost to use Web Serial.

Loading the serial installer runtime.

Device URL

Apply Setup

Configure WiFi over USB if the serial dialog did not already show the WiFi form. When the device joins the network, its URL should appear here automatically.

Device URL or IP

Waiting for a device URL.

Use Chrome, Edge, or another browser with Web Serial support. Open this installer over HTTPS or localhost to use Web Serial.

Launch

Open The Web UI

If the test pattern worked, continue into the device UI to choose effects, tune settings, and monitor performance.

Setup is ready once the device URL responds.